If you do not have pilot pressure for the pump it puts it on stand by. When you have pilot pressure for the pump it increases the pressure while it depends on the transmission issue of using the DRT1 or DRT2. This type of control is made just for load pressure control. If you look […]
DRT 1/2 Counterbalance Pilot Pressure Control On A Load Pressure Control Read More »
The parts that make up a cylinder are; body, pistons that move and the piston rod that is hooked to the piston. There are also end caps that are connected to the cylinder body barrel by way of threads, keeper rings, tie rods or a weld. A rod gland is a cylinder rod that goes
You can get with the factory and custom order your cylinders. They do offer lower pressure cylinders also. There are large bore cylinders that go up to 24″ and as much as 30′ long. Also, you will need to let them know about different sizes or if you want it standard when ordering. There are
Series 300 This series was made to control a single acting cylinder or a uni directional motor. It is a 3 way/3 position. The 3 position B port is the power, neutral and exhaust (power port) and A port is the plugged. They spring centered when it is in the neutral setting and coincide with
SP Control The spools are honed out for superb fit and for load hold performances. These come in 3 way/4way or you can have both on there. The block comes 1,2,3 spool layout and for special orders they come with options on the spools like bonnet assy and ports. It has adjustable or non adjustable
hese valves are used to remotely control the refuse packer trucks and a lot of other trucks that have an on and off hydraulic system that is started up with a primary engine. This takes the need away for having a clutch assembly. The horsepower is minimized by clearing out the non operating mode when
Down below tells your standard sizes for cylinders on bore size, rod size and about special cylinders. If you need a special cylinder, that would have to be ordered or made. The diagram below tells about different kinds of cylinders and you can put different kinds on mounts on any and all cylinders. We specialize
It is essential you know certain things before getting seal for whatever unit you are working on. You will need to know the pressure range, temperature range, maximum diametrical clearance and seal width. The main reason a seal wears out is the clearance gap. They can be pinched or cut into, if not seated properly.
Here are several characteristics of these types of pumps. It has five different displacements, .88, 1.25, 2.09, 2.62 and 3.78 cubic inches per rotation Straightforward Design and built to last. The size is small so it can be put in tight spaces and runs quietly. The displacement is adjustable to help with flow rate needs
HPV Series Hydraulic Piston Pump – Mounting Flange Read More »