Mating connector and terminal part numbers Connector #1201 5792 Terminals #1208 9040 Cable Seal #1201 5323 When you are putting the servo control valve together some hydraulic fluid can come out, when trying to take out the neutral lockout switch and adapter assy. Make sure you cut off the hydraulic reservoir to the pump and […]
When putting this together have the unit’s shaft in a level position and the valve block mounting is facing up. Turn the shaft til the keyway in the auxiliary shaft til you get to 12:00 position. This shows being assembled for a RH rotation. Put in the dowel pin in the hole in the port
Denison Goldcup Hydraulic Pump 6C, 7A, & 8A – Gerotor and Barrel Hold-down Read More »
You can take off the valve manifold assy and reinstated as a whole unit. The instructions show you how to take it apart. Take off the hex cap screws and raise up the manifold off the motor end cap. There are two ports that are closed off with orings and two joining ports that have
Sundstrand Sauer Danfoss Series 10/38 – Change Valve Block Read More »
If you need further info on this unit, contact us at 662-871-8403 or at [email protected]
Tupelo Hydraulics would like to talk about Reservoirs and the different types and its importance: Industrial reservoirs come in a variety of styles among which are the L shaped,overhead and the conventional reservoir. Besides acting as a fluid container, a reservoir serves also to cool the fluid, to allow contamination to settle out and to
Parts diagram breakdown of this unit. Helps tell where parts go and what parts you do need to do a repair job. It is helpful to take to your mechanic for repairs. If we can assist with type of vane motor or any other types of motors or pumps, let us know..we handle all brands.
The motor needs to be filled up with fluid (fill the case chamber), start on low speed and don’t put a load pressure on it til you bleed it out. If not used in awhile, fluid can leak out thru the case in the lines. Fluid needs to be in the lines to start it
A variable displacement pump is a device that converts mechanical energy to hydraulic fluid energy. The displacement, or amount of fluid pumped per revolution of the pump’s input shaft can be varied while the pump is running. Many variable displacement pumps are “reversible”, meaning that they can act as a hydraulic motor and convert fluid
Dynapower Series 4.5 & 6.0 Phase lV Variable Displacement Pump Read More »
Let us know if you need repairs done on a Parker/Denison pump or motor. Call us at 662-871-8403 [email protected]
Parker/Denison Hydraulics T6ED – T6EDM – T6EDP Vane-Type D Read More »
If you have a question or if you need your unit repaired, call us at 800-361-0068 [email protected]