The motor needs to be filled up with fluid (fill the case chamber), start on low speed and don’t put a load pressure on it til you bleed it out. If not used in awhile, fluid can leak out thru the case in the lines. Fluid needs to be in the lines to start it […]
Meaning of model code for example HBOL-F2-2/0-lP-6P HBOL = H – high pressure shaft seal used for pressure priming L = L – 5.4 GPM – 3000 PSI Max. M = M – 3.1 GPM – 5000 PSI Max H = H – 1.65 GPM – 10000 PSI Max F2 = seals for Ester Fluid
They are making the charge relief valve adjustable in a wide variety of pressure changes that are for 290m 348 and 406 PSI. It also changes the poppet and plug. It may stick out from the pump end cap alittle more than the older model. You will need to put in a gauge to tell
Fluids Hydraulic fluids used with Sundstrand-Sauer products should be selected with assistance from a reputable supplier, (Hydrostatic Transmission),following the guidelines presented in the “Fluid Quality Requirements” bulletin, BLN-9887. Start-Up Procedure It is important to follow the procedures for a new Series 40 – Sundstrand Sauer Hydrostatic Transmission for installing or restarting an installation on a
Series 40 -Sundstrand Sauer – Start-Up & Maintenance Read More »
Small cylinders are reliable, save space and cost very little. Most have a minimum length of 2 3/4″ long. They have some that are double acting cylinders for pressures as high as 5000 PSI. Some have 1/2″ to 3″ bore in any stroke to 72″. It has a standard lip type rod seals that get
They may be mini in size but they are linear resistant transducers can tell the position of a cylinder and send out a signal to other electronics.These kinds of cylinders have a .002″ repeatability, 500 million inches of travel life, 5000 PSI, zero to 10DC response and they have side connectors that let you mount
Mini Electronic Cylinders and Different Types of Controllers Read More »
hese valves are used to remotely control the refuse packer trucks and a lot of other trucks that have an on and off hydraulic system that is started up with a primary engine. This takes the need away for having a clutch assembly. The horsepower is minimized by clearing out the non operating mode when
Here are several characteristics of these types of pumps. It has five different displacements, .88, 1.25, 2.09, 2.62 and 3.78 cubic inches per rotation Straightforward Design and built to last. The size is small so it can be put in tight spaces and runs quietly. The displacement is adjustable to help with flow rate needs
HPV Series Hydraulic Piston Pump – Mounting Flange Read More »