They are making changes to the 55cc, 75cc and 100cc fixed displacement motor and 55cc/75cc variable displacement motors. Right now it has an indented seat in the endcap. It gave it a more wearable area for the charge pressure relief valve poppet. Now it has been machined to sit right into the surface that it […]
Sundstrand Series 90/100cc – Charge Relief Seat Change Read More »
To assemble this put the retaining ring and check valve balls in the holes of the pintle. Push a new check valve into the holes and push it hard enough it goes past the coil pin allowance. And don’t push so hard you make the retaining rings you make the check valves come out
This is done in metric diimensions. Let us know if we can assist you with answers to questions or if we can repair your unit. 662-871-8403 800-361-0068 [email protected] [email protected]
If you need more info on controls or any Racine pumps and motors, call us at 800-361-0068 or 662-871-8403 [email protected] or [email protected]
If you need more assistance with this unit or any others, call us at 800-361-0068 [email protected]
Rexroth A10VO28 DR(DRG, DFR, DFR1)/52R(L)-VXC61(64)N00 Series 28 Read More »
PVF-PSTO-12* *-01 P = Higher Standard Compensator S= look for the diagram for screw volume control B,C,E = look on the diagrams below for parts list for springs R,L,D = see which letter matches up with the letter on your pump code. *goes with bodies 221458 and 221581 only chart on the right – adaptor
A. Put in two dowel pins and a gasket on the end cover, make sure to put grease on the bearing shims and cup before you put them in the end cover. B,D & E. You will need to look at the end play of your output drive shaft. Put in the end cover so
Eaton Fixed Displacement Motor Series 33 thru 64 Read More »
Limit of viscosity rangeFor operating applications you will need to follow these guidlines:nmín = 60 SUS (10 mm2/s) for not so long periods (t £ 1 min) at max. perm. The fluid temperature of 239 °F (115 °C). Make a note that the max. leakage fluid temperature of 239 °F (115 °C) doesn’t go over
If we can assist you with answering questions or repairing your unit, call us at 800-361-0068 [email protected]
Sundstrand Series 15 Pumps/Motors – Troubleshooting Read More »
Swashplate hold down pin and motor shaft changes. If you need further assistance with this or any Sundstrand Pump and Motor, call us at 662-871-8403 or 800-361-0068 [email protected] [email protected]